Come on!! I can't believe no one went out to check for this on their own cars after reading about this...!
None of the moderators...nobody?!
None of the moderators...nobody?!
gasket, such as it is, very thin, 1/4 inch rubber, flimsy, and insubstantial, along the very top of the windshield glass
The gasket runs along a very shallow channel, "separating" the top edge of the windshield glass from the actual forward edge of the roof.
It is not sitting in its tiny channel, except at the ends on both sides, hanging down on the windshield for about 1/2 inch.
This does not seem right. It seems to me that the windshield glass should be better protected.
Should I apply some sort of gasket cement along its very shallow channel?
![Automotive lighting Vehicle Wheel Hood Motor vehicle]()
Thanks for all replies!
It is not sitting in its tiny channel, except at the ends on both sides, hanging down on the windshield for about 1/2 inch.
This does not seem right. It seems to me that the windshield glass should be better protected.
Should I apply some sort of gasket cement along its very shallow channel?
Thanks for all replies!
